Workmanship. Finished items shall be clean, well made, and free from any defect which may affect appearance or serviceability. Except for specified cutting edges or fork tine tips, there shall be no sharp edges, burrs, rough die, tool, gouge or grind marks. The silver plating of type I items shall be smooth, fine grained, adherent, and free from visible blisters, pits, porosity, and indications of burning or excessive edge buildup. The finished items shall be not fractured, dented, bent, punctured or malformed.
Quality assurance provisions.
First article. When specified (see notes), the supplier shall furnish samples of the items to be procured under this commercial item description (CID) for the first article inspection, testing and approval (see quality assurance provisions).
Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contract or order, the contractor may use his own or any other facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure that supplies and services conform to prescribed requirements.
First article inspection. When a first article inspection is required by the user, the visual examination and testing shall be in accordance with the following paragraph as applicable. The failure of any of the test or examinations shall be cause for rejection of the first article.
Inspection. Sampling for inspection shall be in accordance with MIL-STD-105, Sampling Procedures and Tables for Inspection by Attributes, except where otherwise.
Component and material inspection. In accordance with responsibility for inspection above, components and materials shall be inspected and tested in accordance with all referenced documents unless otherwise excluded, amended or qualified in this CID or applicable procurement document.
Weight of blank. One gross of each item, randomly selected, from production lot shall be weighed to determine conformance to table I. Any total weight that falls below the specified minimum shall be cause of rejection of the lot
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business